Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

To avoid accident, cut off the power supply before operation according to the following
instruction.
1. The machine had been disinfected before departed from factory.
Cleaning the dispenser prior to install a full bottle of water for the first time.
2. Cleaning and draining instruction:
a) Before cleaning, make sure the power switch in the O(off) position and unplug the water
dispenser.
b)Twist out the two screws ①, then take down top cover, cold tank cover and separator ②.
c)Fill 0.6 gallons pure water into cold tank to clean it.
d) Place a large water bucket beneath the drain outlet which on the back of water dispenser, then
remove the drain cover and drain the water ③.
e)Reposition the drain cover, separator, cold tank cover and top cover after draining. Ensure the
pipe and wires are connected properly , then, you can use the machine normally.
Attention: 1) The cleaning must be under the guidance of professional staff.
2)The dispenser heats water to a temperature of approximately 85℃. It can cause
severe burns. Please operate it carefully.
3.Sanitizing
The machine should be disinfected with the disinfectant separately bought from drugstore or
marketplace according to the instruction manual of the disinfectant and then clean it with water
(see cleaning and draining instruction). Generally this should be done every three months.
4.To remove mineral deposits:
Mix 4 liters water with 200g citric acid crystals, inject into the machine and make sure the water can
flow out of the hot water tap. Switch on the power and heat it about 10 minutes, 30 minutes later,
drain off the liquid and clean it with water for two or three times. Generally this should be done every
six months.
Never disassemble this machine by yourself to avoid danger from damaged machine.

CLEANING

English-7

Hide quick links:

Publicidad

Tabla de contenido
loading

Tabla de contenido