KAISDA K4 Manual De Instalación página 5

4.2. Do not attempt to turn on the battery.
4.3.
If the battery is damaged in a crash or cycling accident, there is a risk of
electrolyte leakage. Beware of chemical burns!And immediately stop using
damaged batteries.
4.4
Do not touch the battery without a cloth or gloves, and make sure the acid
does not touch your eyes.
5. The charging method
1. When the battery of an electric bicycle needs to be charged, just put the bicycle in
the place where the power supply can reach it. First, connect the charging plug of the
charger to the charging seat on the battery, and then plug in the power plug of the
charger to charge.
2. The battery can be installed on the bicycle for charging, or it can be taken out and
placed in a convenient place for charging.
3. The red light means the battery is charging, and the green light means the battery
is fully charged (wait for 30 minutes after the green light of the charger is displayed
before unplugging it).Charging time depends on the battery capacity, the general
charging time is 4-6 hours.
4. Warning:
Do not charge for more than 10 hours. Keep away from high temperature
environment and store in a cool place.
6 . Installation instructions
Open the carton of the electric bicycle, take out the electric bicycle, and cut off
1.
the wrapping rope with tools.
2.
Handlebar installation
2.1
Turn the riser clockwise until it is level with the frame.
3.Loosen the screws on both sides of the riser to adjust the tightness of the front fork
and the frame head pipe.
4.Adjust the proper tightness of the front fork with an M5 hexagon wrench.Tighten it
（2.2） after adjusting it.
2.4. Adjust the correct position of the handlebar, and then use the tool to lock the
lever cover.
:
-3-