Installation; Prior To Use Of The Product - Hisense GM642XS Manual De Usuario E Instrucciones De Instalación

2. INSTALLATION

2.1.

Prior to use of the product

Make sure the power and/or gas installation is suitable. If not, make
the necessary arrangements by means of qualified technical and installer.
The customer shall be responsible for preparation of the place where
the product shall be placed as well as the power and/or gas installation.
For installation of the product, you should comply with the rules
specified in the local standards concerning power and/or gas
Control the product prior to installation to find out whether there is
any damage or not. If the product is damaged, do not make the installation.
The damaged products may cause risk for your safety.
Any works on the gas equipment and system should be performed by
authorized and qualified persons.
The products have no system for discharge of gas that may occur as a
result of burning. The product should be installed and connected as per the
applicable regulations concerning installation. You should observe the
requirements regarding ventilation.
Air necessary for burning is taken from the room air and the emitted
gases are directly given to the room.
A good ventilation is required in the room for safe operation of your
product. If there is no window or door to be used for ventilation of the
room, an additional ventilation system should be installed.
The floor area of the kitchen should be bigger than 8m².
Kitchen volume should be bigger than 20m³.
The chimney outlet should be at height of 1.80m from the floor and
in diameter of 150mm directly opening to the atmosphere.
6