Working With The Device - MSW -OD-68 Manual De Instrucciones

3.4. Working with the device

The product is designed for use with compressed air source. Take special care and
observe the principles of safe compressed air source usage.
3.4.1. GRAVITATIONAL OIL DRAINING:
1. Lift the vehicle (make sure it is properly secured).
2. Place the drainer under the vehicle in such a manner that the funnel bowl of the
product is located directly under the oil sump or the oil sump drain plug.
3. Unscrew the oil inlet valve on the drain pipe and then the drain plug in the sump,
or carefully remove the sump (e.g. in automatic transmissions).
4. Control the oil draining process.
5. After completing the task screw the draining plug on, close the inlet vale and
remove the product from under the vehicle.
3.4.2. PNEUMATIC OIL DRAINING: (MSW-ODE-68 and MSW-ODE-70
model):
1. Ensure that all valves are closed, then connect the pressure hose to the
connection.
2. Select the end of the suction hose (probe) with the appropriate diameter to insert
it into the oil dipstick hole and install it on the suction hose.
3. Insert the end of the suction hose (probe) into the tube of the oil dipstick on the
engine (or automatic gearbox, etc.) - the dipstick must be removed.
4. Open the valve upstream of the connection.