gefran GFX OP Manual De Uso página 12

Description of "LoAd" function (GFX_OP -----> Geflex)
It activates when the "L" key is pressed, and asks confirmation of the configuration number, one of the 10 possible
numbers (codes 0-9) that you want to load in the Geflex; code 10 = exit.
The display will show the message "LoAd" with the proposed number corresponding to the least significant digit in
the ID field: for example, if the ID is 15, the number of the proposed configuration is 5.
Press key "F" to proceed.
During updating of the data in Geflex, only the "ones" point will flash on the ID display.
In master mode (connected to Geflex), correspondence of the software version is checked when the message
"LoAd" appears and a saved configuration is selected. If the version differs from that in the Geflex in dialog, the
configuration number will flash; if it is the same, the number will not flash.
The configuration number also flashes if it has never been used to save data.
In slave mode (connected to Winstrum), the configuration number does not flash.
Description of "Stor" function (Geflex -----> GFX_OP)
It activates when the "S" key is pressed, and asks confirmation of the configuration number, one of the 10 possible
numbers (codes 0-9) that you want to save the configuration; code 10 = exit.
The display will show the message "Stor" with the proposed number corresponding to the least significant digit in
the ID field: for example, if the ID is 23, the number of the proposed configuration is 3.
Press key "F" to proceed.
3 • AUTOMATIC SCROLLING" FUNCTION
1. Description
If the function is on (parameter OP.t = 1), the operator terminal automatically runs "scrolling" of the connected
Geflexes from a set first ID code "FST" to a set last code "LST".
When the "LST" code is reached, the scan restarts.
The initial reading of configuration parameters takes place with each new ID code, followed by continuous reading
of state variables (PV, SSP, POWER, main function state).
A single Geflex is monitored for a settable time "CYC."
If a Geflex (ID) is not present, or does not communicate in Modbus, switching to the next one is almost immediate
(after a brief wait needed to confirm non-communication state).
During scrolling, you can manually switch to another ID code at any time with the Raise and Lower keys.
Scrolling resumes after time CYC from the newly set code.
Press any key to suspend scrolling. In this way, you can display or change the configuration of a single Geflex, run
LOAD and SAVE procedures, or activate enabled functions with the configurable key.
After time CYC has lapsed without any key having been activated, the cycle resumes from the current ID code.
12