gefran GFX OP Manual De Uso página 13

4 • PROGRAMMING and CONFIGURATION MENU
LEVEL 1 MENU
P.V.
Process variable
spa
Active Setpoint
sp
Local Setpoint
-
SP. 1
Setpoint 1
SP. 2
Setpoint 2
Remote Setpoint
SP. r S
not memorized in eeprom
I. t A1
Ammeter input value
I. t A2
Ammeter input value
I. t A3
Ammeter input value
I. t U1
Voltmetric input value
I. t U2
Voltmetric input value
I. t U3
Voltmetric input value
al. 1
Alarm point 1 (scale points)
al. 2
Alarm point 2 (scale points)
al. 3
Alarm point 3 (scale points)
al. 4
Alarm point 4 (scale points)
Heater break alarm point
a. x b1
(scale points of ammeter input)
a. x b2 Heater break alarm point
(scale points of ammeter input)
Heater break alarm point
a. x b3
(scale points of ammeter input)
Control output value (+Heat / -Cool)
(parameter settable only if Geflex is in
0V. P
manual mode [MAN LED on])
The automatic return to PV/SV display is
disabled when "manual valve control" is active
If Inc, Dec, F keys are not pressed within 15 sec,
display returns automatically to P.V. value
N.B.: Once a particular configuration is entered, all unnecessary parameters are no longer displayed
The displayed parameters depend on the firmware release of the selected Geflex.
For the list and meaning of parameters shown in different menus, please refer to the Geflex user manual.
INFO
CFG
SEr
InP
Out
PAS
NO
PAS = 99
Pro
Hrd
Lin
U.CA
13
Information display
Custom menu
Serial communication
Input settings
Keep the F key
pressed to scroll
the menus.
Output settings
Release the F key
to select the
displayed menu.
Password
Press the F key to
access the
parameters.
Keep the F key
Protection code
pressed to exit
any menu.
Hardware configuration
Keep F + Auto/Man
keys pressed for 2
sec. on any menu
to go immediately
Input linearization to level 1 display
You can
immediately go to
the previous
Potentiometer
parameter by
input calibration
pressing the
Auto/Man + F keys
on any menu.