Front Panel - Intellinet Network Solutions 508964 Instrucciones

Power
Terminal Block Installation
NOTE: Ensure all power is off/disconnected before beginning!
1 Loosen appropriate screws. Insert bare power-supply wires into appropriate terminals (positive wire into
positive [V1+] terminal, negative wire into negative [V1-] terminal, ground wire to ground [GND] terminal).
2 Tighten appropriate screws to secure wires. Repeat these steps for
a second power supply if desired (V2+, V2-, GND).
3 Install block into the device.

Front panel

DIP Switch — PT/SF
PT SF
OFF OFF
Forward mode
ON OFF
Through mode
OFF ON
Converter mode
ON ON
DIP Switch — NC/LFP
Switch Position
NC
ON
LFP
OFF
LED Color
PWR1/PWR2
Green
FL/A Green
100M Yellow
TL/A Green
Function
Store and Frames are stored in the memory and checked for errors. If the frame passes the
check, it is forwarded to the appropriate port. Note: Function may cause latency.
Modified Cut Checks the first 64 bytes of a frame, and if no issue,
frame is forwarded to the destination address.
Frames are forwarded as soon as the destination address is identified.
Note: Function helps reduce latency and saves buffer space, but
may forward bad frames which can create broadcast storms.
Link Fault Pass Through enabled: Devices on a link must acknowledge that they are online
before data can be transmitted. When one of the devices doesn't respond, data cannot be sent.
Status Description
On Power channel is powered.
Off Power channel is not powered.
On Fiber port is connected.
Off Fiber port is not connected.
Flashing Sending or receiving data.
On 100 Mbps speed
Off 10 Mbps speed
On Valid port connection
Off Connection not established.
Flashing Sending or receiving data.
Description
Description
Unused
Link Fault Pass Through disabled
Instructions
English 3