KENMORE ELITE KKEOVSMG Manual De Uso Y Cuidado página 4

OPERATION
ATTACHING 360° SPLASH GUARD
(See Fig. 4)
1. Turn speed dial to 0.
2. Unplug mixer from electrical outlet.
3. Press down release lever to tilt head back.
4. Push the splash guard up to t onto the seating
ring on the underside of the Tilt Head.
NOTE
As an optional attachment method, lay the splash
guard on top of the bowl and lower the Tilt Head
onto it.
REMOVING 360° SPLASH GUARD
1. Turn speed dial to 0.
2. Unplug mixer from electrical outlet.
3. Press down release lever to tilt head back.
4. Pull o the splash guard.
WARNING
Never turn on Mixer with accessories attached unless the Bowl is in place.
ATTACHING MIXING ACCESSORIES
(See Fig. 5)
1. Turn speed dial to 0.
2. Unplug mixer from electrical outlet.
3. Press down release lever to tilt head back.
4. Align slot at the top of accessory with pin on Tilt Head
shaft. Push accessory up onto shaft and turn counter-
clockwise until pin moves all the way into the slot.
REMOVING MIXING ACCESSORIES
1. Turn speed dial to 0.
2. Unplug mixer from electrical outlet.
3. Press down release lever to tilt head back.
4. Turn Accessory clockwise on shaft until pin on shaft
lines up with slot on accessory. Pull accessory o shaft.
seating ring
6
OPERATION
SPEED CONTROL DIAL
(See Fig. 6)
- The Speed Control Dial is located on the right side of the
Mixer, and is scaled in digits from 0 to 10 (0 equals OFF).
- To start the Mixer, turn the Speed Control Dial clockwise
from 0.
- When using the Splash Guard, you may immediately turn
the dial to the optimum speed of your recipe.
- If not using the Splash Guard, start the mixer on the slowest
possible speed andgradually raise to optimum speed to avoid
splashing ingredients out of the bowl.
OPERATION SAFETY FEATURES
- If the mixer is plugged into an outlet when the speed dial is turned to a speed setting, the mixer
will not start and the work light will ash. Unplug the cord and turn the speed dial to 0 before
plugging it back in.
- If you attempt to lift the tilt head while the mixer is running, the mixer will shut o and the work
light will go out. When you lower the head back into place, the work light will ash. Turn speed
dial to 0 and then to a speed setting to restart mixer.
- If the mixer motor becomes overheated, the mixer will shut o and the work light will ash. Turn
the speed dial to 0 and allow mixer motor to cool down before restarting.
CAUTION
When you are nished mixing, turn the speed dial to 0 and unplug
Mixer from the electrical outlet to prevent accidental starting.
CAUTION
Do not scrape the bowl while the Mixer is operating.
The bowl and beater are designed to provide thorough mixing without
frequent scraping. Scraping the bowl once or twice during mixing is
usually su cient. Turn the Mixer o (Speed Dial to 0) before scraping.
speed digit
7