All manuals and user guides at all-guides.com
During initial setup
1
M ake sure the receiving device is able to
respond. E.g. when you try to repair the Play
button for your DVD player, make sure to
insert a DVD into the DVD player otherwise
the Play button is not able to function.
2
P ress the button that does not function, keep
it pressed and immediately release it when
the device responds. Repeat this for every
button that does not function.
• I f the button still does not function as
expected, try pressing it again for a longer
period of time.
After initial setup
1
M ake sure the receiving device is able to
respond. E.g. when you try to repair the Play
button for your DVD player, make sure to
insert a DVD into the DVD player otherwise
the Play button is not able to function.
2
S elect the device
that you wish to
operate (e.g. DVD).
P ress the
device selection
button to select
DVD.
3 K eep buttons
and
simultaneously for
5 seconds.
• T he red Setup
light lights
up. The remote control is now in setup
mode.
4 P ress and hold the button that does not
function and immediately release it when the
device responds.
• I f the button still does not function as
expected, try pressing it again for a longer
period of time.
5
P ress the
selection button
twice to save your
settings and exit
setup mode.
•
W hen no
button is pressed for 5 minutes or more,
the remote control will exit setup mode,
automatically saving all your settings.
8
EN
SRP2063WM_17__Manual 8
or
5 sec.
pressed
or
2 x
25-11-09 13:11