Fromm & Starck STAR DESK 21 Manual De Instrucciones página 34

3.3.
Working with the device - operating the control
panel
Caution: If using the control panel for the first time, the user should reset the
system before working with the unit.
Resetting the system:
• Press and hold the "down" button (the button must be held until the reset
process is complete). The display will show "r5t" and the desk will begin to lower
the worktop level to its lowest position.
• The desk will then move up slightly and the display will show the current desk
height. The reset process is now complete.
Caution: When a system reset is required, disconnect and reconnect the power to
the desk, and then follow the instructions above.
Height adjustment:
• Press and hold the "up" / "down" button to raise/lower the desk to the desired
height.
Timer Adjuster:
• Press "T" to receive a reminder to change position. Each press of "T" leads to an
increase in the time value by 0.5 hours. The maximum time setting is 2 hours.
• When the timer is successfully set, the light in the upper right corner will be
illuminated.
• After the set time has elapsed, the unit will beep 3 times to remind the user to
change position.
• To clear the reminder, press the "T" button until the indicator light in the upper
right corner goes out.
Memory settings:
• To store the desk height in memory, press the "M" button, "5-" will flash on the
display. Press the 1/2/3 key while flashing to select under which key the position
will be stored.
• To recall the previously stored height, press the 1/2/3 key and the desk will start
to move the desk top to that position. Press any key to stop the movement.
Switching the height unit (centimeters or inches)
• Press and hold down the "T" button for about 3 seconds.
• The unit will beep once when changing units to centimeters (CM), and will beep
twice when changing units to inches (IN).
Caution: Disconnect and reconnect the power supply to the desk when a unit
change is needed.