Cleaning And Maintenance - Fromm & Starck STAR DESK 21 Manual De Instrucciones

Power saving mode:
• If no button is pressed within 1 min, the system will enter power save mode and
the display will dim. Pressing any button will reactivate the control panel.
Error codes and troubleshooting
Error code
ER1
ER2
HOT
ER3
ER5
CAUTION! NEVER disconnect power or reset the system when the system is in
overload mode or thermal protection has activated.
3.4.

Cleaning and maintenance

a) Pull the mains plug and let the unit cool down completely before cleaning,
adjusting or replacing accessories and when the unit is not in use.
b) Use only non-corrosive cleaning agents for cleaning the surfaces.
c) After each cleaning, all the parts should be dried well before the unit is used
again.
Check that the desk is not overloaded. Remove objects from
the desk. If the cause is not an overload, disconnect and
reconnect the power supply.
If the problem persists, contact the manufacturer for further
assistance.
Allow the desk motor to cool and remain idle for
approximately 20 minutes. If the problem persists, contact
the manufacturer for further assistance.
Allow the desk motor to cool and remain idle for
approximately 20 minutes. If the problem persists, contact
the manufacturer for further assistance.
The wires have been disconnected. Disconnect and
reconnect the cables between the speakers and the power
supply. Disconnect and reconnect the power supply, then
reset the system.
If the problem persists, contact the manufacturer for further
assistance.
There are two possibilities:
1. Ensure that the original AC adapter is used.
2. An overload has occurred. Remove objects from the desk.
Disconnect and reconnect the power supply. If the problem
persists, contact the manufacturer for further assistance.
Solution