Bt Connection - auna SELECT Drive Manual De Instrucciones

EN
24
Bass setting
• Turn the BASS knob on the front of the device.
• The adjustment range is ± 8 dB.
Treble setting
• Turn the TREBLE knob on the front of the device.
• The adjustment range is ± 8 dB.
Sound
1. Adjusting the volume: to adjust the volume, turn the VOLUME/MUTE
knob on the front of the device or press the volume buttons on the
remote control. The volume is indicated on the LED display.
2. Mute (the volume will temporarily fade out): press VOLUME/MUTE on
the front of the device or press the MUTE button on the remote control.
The LED display lights up red. Press the corresponding button again to
turn the volume back on.

BT CONNECTION

1. Turn the SOURCE/SPEAKER knob on the front of the device or press the
INPUT UP/DOWN buttons on the remote control until the BT display
lights up.
2. After a few seconds, the BT LED flashes. This means that the device is in
search mode and can detect other BT devices.
3. Activate BT on the mobile device you want to connect to the amplifier.
The device is displayed in the device list of the mobile device as "Drive".
Select this device from the device list to establish a connection.
4. If it is necessary to enter a password, enter "0000" to agree to the
connection.
5. After the connection has been successfully established, the BT LED
lights up steady white and no longer flashes.