Remote Control; Initial Setup - Xtech XTS-450 Guía De Instalación Rápida

Connectors
1. AUX input
These RCA jacks allow the connection of audio devices tted
with a 3.5mm plug.
2. DVD inputs Provides the connection of additional audio components
with full 5.1 channel capability
Connect all ve satellites in this jack block, matching the
3. Speaker output connections
label of each speaker with the corresponding connectors on
the main unit.
3.1 FR The front right speaker must be connected here.
3.2 FL The front left speaker must be connected here.
3.3 SR
The surround (rear) right speaker must be connected here.
3.4 SL
The surround (rear) left speaker must be connected here.
3.5 CEN The center speaker must be connected here.
4. Main power switch Turns the speaker on and o .
5. Voltage selector switch Select 110V or 220V to match the utility voltage used in your
area.
6. AC power cord Insert the power cord plug in an AC outlet.

Remote control

1
5
8
12
14
15
17
Description
2 3
4
20
7
6
9
10
11
13
16
18
19
Buttons
1. Standby button
Press this button to alternate between the standby and
active modes on the device
2. Memory button Press it to store your favorite channels for quick recall
3. Preset button Use it to call memorized channels
4. Mute button Cancels the audio coming from the speaker. Press it again to
unmute the speaker
5. DVD/Aux button Toggles the input mode between these two RCA wired
connections
6. Pro Logic This button switches the decoder between 2.1 and 5.1 audio
channels
7. Bluetooth® and USB/SD™ button
Toggles the input mode between the wireless connection
and digital storage devices.
8. Front button Selects the front speaker to adjust its output level
individually using the volume keys.
9. Center button
Selects the central speaker to adjust its output level
individually using the volume keys.
10. Vol + Increases the volume level coming from the speaker system
Press to start and pause media during Bluetooth®, SD™ or
11. USB audio playback.
12. Takes you back to the previous track on your play list.
Available in Bluetooth®, SD™ and USB modes.
13. Takes you to the next track on your play list. Available in
Bluetooth®, SD™ and USB modes
14. Vol Lowers the volume level coming from the speaker system
Selects the surround (rear) speaker to adjust its output level
15. Surround button individually using the volume keys
Selects the subwoofer speaker to adjust its output level
16. Subwoofer button individually using the volume keys
Press any key from 0 to 9 on the remote to choose directly
17. Numbered keypad
the tracks or channels you want to play.
18. Tuning + button Press it to scan memorized channels in an upward direction.
19. Tuning button Press it to scan memorized channels in a downward direction.
20. Tuner This button enables the tuner mode.
III. Initial setup
1. Start by verifying the AC input on the back of the main unit. Choose 110V or 220V
according to the mains power available in your area.
2. Then, install the two AAA supplied batteries inside the remote control.
3. Next, connect the front, center and rear satellite speakers to the corresponding output
connectors on the back of the main unit.
4. Connect the left (red) and right (white) RCA plugs into the matching input jacks on the
back of the main unit for wired playback from audio devices tted with a 3.5mm stereo
Description