Sebson GS559A Manual Del Usuario página 17

RESET-Mode:
In order to perform a RESET, proceed as follows:
1. Remove the batteries.
2. Press and hold the TEST button while reinserting the batteries. Pay attention to the correct polarity!
3. The LED lights solid red for about 3 seconds after inserting the batteries. Note: Keep and hold the TEST
button pressed!
4. When the LED light turns off, release the TEST button.
5. The LED light turns on. Press the TEST button again.The RESET process is completed by a short beep
sound.
Explanation of the LED modes :
LED flashes every 50 seconds:
LED flashes every second and alarm sounds:
Peep 0,5s –Pause 0,5s - Peep 0,5s – Pause 0,5s
- Peep 0,5s – Pause 1,5s LED flashes – repetition
of the signal:
Alarm sounds 2 x in quick succession and
after one second LED flashes (recurring
signal): Peep – Peep – Pause 1,2s – LED
flashes – repetition of the signal
LED flashes every second and alarm sounds:
Peep 0,2s – Pause 0,1s – LED flashes –
repetition of the signal:
LED flashes every 16 seconds:
LED flashes every 50 seconds and a short
alarm tone sounds:
Every 50 seconds a short alarm tone sounds
and LED doesn´t flash:
Installation (Fig.8) :
1: Dowels
2. Mounting base
3. Holes for screws for fixing
4: Guide pins for orientation when attaching the device to the mounting plate
5: Screws
6: Retainer of the bayonet connection
The smoke alarm detector is working properly..
TEST button is pressed or the alarm has been triggered by
smoke. (Local smoke alarm signal)
TEST button is pressed or the alarm has been triggered by
smoke. (Radio alarm signal)
Alarm has been triggered by heat (local heat alarm signal)
The unit is in the silent mode
Batteries are low. Replace the batteries!
The unit is defective or the maximum service life has been
reached. Replace the unit
17