Assembly - Power Stroke PS903655 Serie Manual Del Operador

UNPACKING
This product requires assembly.
 Carefully cut the box down the sides then remove the
machine and any accessories from the box. Make sure
that all items listed in the loose parts list are included.
NOTE: This machine is heavy and requires a minimum of
two people to lift. To avoid back injury, lift with your legs
and not your back.
WARNING:
Do not use this product if any parts on the Loose Parts
List are already assembled to your product when you
unpack it. Parts on this list are not assembled to the
product by the manufacturer and require customer instal-
lation. Use of a product that may have been improperly
assembled could result in serious personal injury.
 Inspect the unit carefully to make sure no damage
occurred during shipping.
 Do not discard the packing material until you have
carefully inspected and satisfactorily operated the
product.
 If any parts are damaged or missing, please call
1-877-617-3501 (US) or 01 800 843 11 11 (MX), for
assistance.
WARNING:
If any parts are damaged or missing do not operate
this product until the parts are replaced. Use of this
product with damaged or missing parts could result in
serious personal injury.
WARNING:
Do not attempt to modify this product or create acces-
sories not recommended for use with this product. Any
such alteration or modification is misuse and could result
in a hazardous condition leading to possible serious per-
sonal injury.
WARNING:
Do not attempt to operate the generator until assembly
is complete. Failure to comply could result in possible
serious personal injury.

ASSEMBLY

LOOSE PARTS LIST
See Figure 2.
The following items are included with the generator:
Key
No. Description
1 Bolts (1/4-20 x 2 mm) ..........................................2
2 Wing Nuts (1/4-20) ..............................................5
3 Wheels .................................................................2
4 Bolts (3/8 x 16 mm) .............................................2
5 Support Feet ........................................................2
6 Handle .................................................................1
7 Washer (1/4-20) ...................................................4
8 Spacer .................................................................2
9 Handle Bracket ....................................................1
10 Bolts (1/4-20 x 1.5 mm) .......................................3
11 Lock Nut (3/8) ......................................................2
12 Bottle of Engine Lubricant ...................................1
Operator's Manual (not shown) ...........................1
TOOLS NEEDED
See Figure 3.
The following tools (not included or drawn to scale) are
needed for assembly:
 11 mm and 14 mm Socket Wrench
 11 mm and 14 mm Combination Wrench
NOTE: Do not put fuel or lubricant in the generator before
installing the feet and wheels.
INSTALLING SUPPORT FEET
See Figure 4.
 Raise the end of the generator where the recoil starter is
located high enough to gain access to the frame bottom;
securely position props underneath to support.
 Locate the following items:
2 Support Feet
2 Wing Nuts (1/4-20)
2 Washers (1/4-20)
2 Bolts (1/4-20 x 2 mm)
 Insert bolt through the foot and frame as shown.
 Slide washer onto the bolt and install wing nut. Tighten
securely.
NOTE: Be careful not to overtighten so that foot mate-
rial collapses.
 Repeat with remaining foot.
Page 11 — English
Qty.