Installing The Grille - Homewerks 7136-02HW Guía De Uso Y Cuidado

Installation - New Construction (continued)
3
Securing suspension brackets onto
the fan housing
□ Secure suspension brackets (EE, FF) to the fan housing (A)
using the two machine screws (BB) and secure suspension
bracket (DD) to the other side of housing using the short
machine screw (CC).
4
Wiring the fan housing
□ Remove the wiring cover from the fan housing (A). Pull the house
wires through the wiring cover hole. Using the attached quick
connectors, secure 120V house wiring from the wall switch to
the fan as shown in the wiring diagram on page 4. 14 AWG is the
smallest conductor that should be used for branch circuit wiring.
□ Carefully push the connected wires back into the wiring box
housing. Reattach the wiring box cover.
CAUTION: If the house electrical wires do not match the colors
from the fan wiring diagram on page 4, you must determine what
each house wire represents before connecting. You may need to
consult an electrical contractor to determine safety.
5
Connecting the duct
□ Connect a 6 in. circular duct (not supplied) and vent to
the outside. Secure it with duct tape (not supplied) or
a clamp (not supplied) to make the connection secure
and airtight.
□ Turn on the power source. Check the fan for any
abnormal sounds or vibrations.
6

Installing the grille

□ Attach the grille (B) by pinching the mounting springs
and inserting into the narrow rectangular slots in the
fan housing (A).
Slot on the side of the fan housing
DD
CC
EE, FF
House
Wires
Wiring
Cover
Mounting springs
7
BB
A
Quick Connector
Product Wires
A
Homewerks.com
A
B