Setting The Language; Configuring Automatic Operation; Configuring Manual Operation - PEDROLLO E1 MONO Instrucciones Originales De Uso

SELECT

ENABLE WIFI
SELECT

RESTORE DEF
When the control panel is powered up, it enters an initial STARTING phase, after which it automatically enters OPER-
ATION mode or goes out of service (OFF), depending on its state when it was last switched off.

SETTING THE LANGUAGE

Œ
This menu is used to set the control panel interface language
• Open the menu
LANG.CONFIG
• the key to confirm the choice and enter the submenu
• Press the key to set the language
• Press the or key and select the desired language (ITA-ENG-DEU-ESP-FRA)
• Press the key to confirm

CONFIGURING AUTOMATIC OPERATION


This configuration allows the control panel to monitor all the system operating parameters and display them together with
any alarm messages.
• Open the menu
AUTOMATIC
• Press the key to confirm the choice
• The symbol will appear on the control panel display
• Press the ON/OFF
• The pump running symbol will appear on the control panel display:
• The chosen operating mode (1 to 6) will appear on the lower alphanumeric display.
The control panel will always start in automatic MODE 1 the first time it is powered up

CONFIGURING MANUAL OPERATION


This configuration is only intended for qualified personnel who are familiar with system control issues and the specific
characteristics of the control panel.
In manual operating mode, the pumps can only be activated by holding the ON/OFF
pump is deactivated as soon as the key is released.
52 | ENGLISH
Configure Wi-Fi connection
9 ENABLE WIFI
ENABLE:NO
Reset to factory settings
9
RESTORE DEF
CONFIRM?
SELECT
SELECT
key to start the system.
SELECT
LANGUAGE:ENG
and/or
key down. The