Controls + Features - SNOWJOE 24V-X4-SB24 Manual Del Operador

2. Adjust upper handle assembly to the optimal position
by aligning the double bolt holes at the desired height.
Secure the connection using the 4 handle knobs and
bolts, and tighten on each side (Fig. 7).
Fig. 7
2
1
2-position handle
height adjustment
Discharge Chute Assembly
1. Place the discharge chute assembly onto the gear plate,
and push down until the chute is flush and flat against the
housing (Fig. 8).
Fig. 8
Discharge
chute assembly
Gear plate
2. With the holes on the discharge chute pole aligned with
the holes on the housing, use the 12 mm open end
wrench to secure the 2 chute bolts with the discharge
chute assembly (Fig. 9).
Fig. 9
Discharge
chute pole
12 mm wrench end
3. Clip the cord clip onto the lower handle frame, insert the
Fig. 10
Cord clip
Discharge
chute cable

Controls + Features

m
entire safety section before proceeding.
Snow blower controls and features are described below and
illustrated in Fig. 11.
Control Panel (Fig. 11)
Fig. 11
Auger speed
control lever
1. Auger speed control lever – The auger rotation speed
2. LED switch – Press
3. Reverse button – Press
4. Drive speed control lever – Use the drive speed control
Chute bolts
5. Chute control lever – The chute control lever can be used
9
discharge chute cable into the cord clip (Fig. 10).
WARNING!
AVOID INJURY. Read and understand the
LED switch
Reverse
button
can be increased from 116 rpm to 143 rpm by pushing the
auger speed control lever forward.
to utilize the LED lights located
on the front panel for nighttime snow removal.
snow blower in reverse mode. The reverse indicator LED
will light up to indicate the reverse mode is activated.
lever to control the marching speed of the machine. When
machine is marching, push the lever forward to increase
the speed, pull it back to reduce the speed.
to adjust the chute direction up to 180 degree, as well as
to lower/raise the chute deflector.
Reverse indicator LED
Chute
control lever
Drive speed
control lever
reverse button to enter the