Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Change Blade
Remove Blade (Fig. A, C)
1. Insert thin screwdriver into the spindle lock port
2. Insert a flat screwdrivers or coin into the blade bolt
3. Turn blade bolt counterclockwise to loosen and remove bolt.
4. Slide blade
4
Fit New Blade (Fig. A, C)
1. Slide new blade over shoe and align slots in blade against the 2 drive pins
2. Ensure beveled edges
3. Refit blade bolt and tighten.
4. Remove screwdriver from the spindle lock port.
OPERATION
WARNING: To reduce the risk of serious personal injury, turn unit off and lock
the trigger before making any adjustments or removing/installing attachments
or accessories. An accidental start‑up can cause injury.
WARNING: Cut hazard. Keep fingers away from blades.
WARNING: Always use proper eye protection that conforms to ANSI Z87.1(CAN/ CSA
Z94.3) while operating this power tool.
WARNING: Do not operate the cutter while it is charging.
Proper Hand Position (Fig. D)
WARNING: To reduce the risk of serious personal injury, ALWAYS use proper hand position
as shown.
WARNING: To reduce the risk of serious personal injury, ALWAYS hold securely in
anticipation of a sudden reaction.
Proper hand position requires one hand on the main handle.
nOTE: Before cutting any type of material, be sure it is firmly anchored or clamped to
prevent slipping.
1. Always hold cutter firmly while cutting.
2. Lightly place blade against work to be cut as shown in Fig. E.
3. To switch the tool on, pull the trigger
4. Press the lock out button
5. To switch the tool off, release the trigger.
out past the shoe
12
are facing outwards
2
once to make the tool turn on and remain on.
8
.
9
.
1
as shown in Fig. F.
5
slot.
English
.
11
11
Publicidad
Tabla de contenido
