Cleaning And Maintenance - Expondo ulsonix USX-ST1 Manual De Instrucciones

Be especially careful when ironing fabrics decorated with stones,
•
sequins etc., hot steam may damage them.
• Refilling the tank with hot water is prohibited! Pouring hot water may deform
the tank.
• Always turn the machine off when not in use, before moving it to another
location, and when pouring/emptying the water tank.
Check the water level in the water tank. Do not operate the machine with an
•
empty water tank.
Wearing protective gloves when you need to hold clothing during ironing is
•
recommended.
• Using distilled or demineralized water is recommended. Using tap water may
cause limescale to build up in the unit, resulting in reduced performance.
3.4.

Cleaning and maintenance

a) Cleaning and maintenance. Pull the mains plug and let the unit cool down
completely before cleaning, adjusting or replacing accessories and when the
unit is not in use.
b) Use only non-corrosive cleaning agents for cleaning the surfaces.
c) After each cleaning, all the parts should be dried well before the unit is used
again.
d) Store the unit in a dry and cool place protected from moisture and direct
sunlight.
e) Do not spray the unit with a stream of water or immerse it in water.
f) Make sure that no water enters through the ventilation openings in the casing.
g) Clean the ventilation openings with a brush and compressed air.
h) Perform regular inspections of the unit checking technical fitness and any
damages.
i) Always empty the water tank after using the unit to prevent limescale build-
up.