Working With The Unit - Royal Catering RC-HKS03 Manual De Instrucciones

CAUTION! Do not exceed the maximum capacity of the appliance listed in the
technical data table.

3.3. Working with the unit

1. Place the appliance base on a level surface.
2. To fill the tea kettle, remove it from the base and open the lid, fill the tea
kettle with the desired amount of water, then close the lid. Alternatively,
you can fill the tea kettle through a funnel.
3. Place the tea kettle on the base.
4. Connect the plug to the power outlet. Turn the switch to position "1", the
heat light will illuminate. The appliance will begin to boil water, and after
boiling, the switch will automatically return from position "1" to "0". It is
possible to manually turn off the power using the "1/0" switch during
cooking. If you need to boil the water again, move the switch to the "1"
position.
5. Remove the tea kettle from the power base, then pour the water from the
tea kettle into a vessel.
6. The appliance will not boil water again until the "1/0" button is pressed
again. The tea kettle can be stored on the base when not in use.
3.4. Protection against dry boiling
If the unit is accidentally started without water, the protection will automatically turn
off the power. If this happens, wait for the unit to cool down and only after it has cooled
down can it be used again.
3.5. Cleaning and maintenance
a) Pull the mains plug and let the unit cool down completely before cleaning,
adjusting or replacing accessories and when the unit is not in use.
b) Use only non-corrosive cleaning agents for cleaning the surfaces.
c) Only mild detergents designed for cleaning food contact surfaces may be used
to clean the unit.
d) After each cleaning, all the parts should be dried well before the unit is used
again.
e) Store the unit in a dry and cool place protected from moisture and direct
sunlight.
f) Do not spray the unit with a stream of water or immerse it in water.
g) Use a soft, damp cloth for cleaning.
h) Do not use sharp and/or metal objects (e.g. a wire brush or metal spatula) for
cleaning, as these may damage the surface of the material from which the unit
is made.