Environmental Protection - Metabo RWE 1200 Manual Original

en ENGLISH
7. Use
7.1 Tool change
Attach the stirrer:
Screw the stirrer by hand into the spindle (1).
Remove the tool:
Hold the spindle (1) using an open-ended wrench
and fix the stirrer using a second open-ended
wrench.
7.2 Select the gear (depending on features)
Select the required gear by rotating the thumb
wheel (2).
Change speed when the machine is in the process
of running down (briefly switch it on and off).
I = 1. st gear (low speed, high torque)
II = 2. nd gear (high speed)
7.3 Presetting the speed (depending on
features)
Select the maximum speed using the preselection
wheel (5).
(Press in the trigger (3) to increase the rotational
speed.)
7.4 Switching on/off, change speed (for
mains-powered and cordless machines)
Switching on, speed: Press locking button (4) and
keep pressed, then press the trigger switch (3).
Press in the trigger switch to increase the rotational
speed.
To switch off, release the trigger switch (3) or (4).
7.5 Continuous operation (only RWEV)
With the trigger (3) pressed, push in the locking
button (4) completely and release the trigger.
Continuous operation is active. Press and release
the trigger (3) again to switch off.
8. Cleaning
Clean the machine regularly.
9. Troubleshooting
9.1 Mains powered machines:
- Overload protection: There is a MAJOR
reduction in load speed. The motor temperature
is too high! Allow the machine to run at idle speed
10 until it has cooled down.
19
24
- Overload protection: There is a SLIGHT
reduction in load speed. The machine is
overloaded. Reduce the load before continuing to
work.
- Restart protection: The machine does not
start. The restart protection is active. If the mains
plug is inserted with the machine switched on, or if
the power supply is restored following an
interruption, the machine does not start up. Switch
the machine off and on again.
9.2 Cordless machines:
Overload protection: The machine has shut
down by itself. The device is too hot! Allow the
machine to run at idle speed until it has cooled
down.
ENG 10. Accessories
Use only original Metabo or CAS (Cordless Alliance
System) battery packs and accessories.
Battery packs with different capacities. Use battery
packs only with voltage suitable for your power tool.
Use only accessories which fulfil the requirements
and specifications listed in these operating
instructions.
See www.metabo.com or the catalogue for a
complete range of accessories.
11. Repairs
Repairs to electrical tools must ONLY be carried out
by qualified electricians!
A defective mains cable must only be replaced with
a special, original mains cable from metabo, which
is available only from the Metabo service.
Contact your local Metabo representative if you
have Metabo power tools requiring repairs. See
www.metabo.com for addresses.
You can download a list of spare parts from
www.metabo.com.

12. Environmental Protection

Observe national regulations on environmentally
compatible disposal and on the recycling of disused
machines, packaging and accessories.
Packaging materials must be disposed of according
to their labelling in accordance with municipal
guidelines. Further information can be found at
www.metabo.com in the "Service" section.
Only for EU countries: Never dispose of
power tools in your household waste! Used
power tools must be collected separately and
handed in for environmentally compatible recycling
in accordance with European Directive 2012/19/EU
on waste electrical and electronic equipment and its
implementation in national legal systems.
Special notes regarding cordless machines:
Battery packs may not be disposed of with regular
waste. Return faulty or used battery packs to your
Metabo dealer!