Preparing For Use - MSW Motor Technics MSW-AWG-3400 Manual De Instrucciones

3.2.

Preparing for use

APPLIANCE LOCATION
The temperature of environment must not be higher than 40°C and the relative
humidity should be less than 85%. Ensure good ventilation in the room in which
the device is being used. The device should always be used when positioned on an
even, stable, clean, fireproof and dry surface, and be out of the reach of children
and persons with limited mental and sensory functions. Position the device such
that you always have access to the power plug. The power cord connected to the
appliance must be properly grounded and correspond to the technical details on
the product label.
3.3. Device use
Connect the plug to the power supply.
Before welding, set the heater power to the lowest scale.
Then turn the dial to set the desired temperature according to the material
requirements. Press the ON / OFF button.
Do not touch the metal cylinder during operation to avoid burns.
After finishing work, turn off the ON / OFF button.
Do not turn off the power immediately after use.
Set the temperature regulator to "0" to cool the appliance down before turning off the
power.
1. Metal cylinder
2. Temperature controller
3. ON/OFF button
4. Power cord