Cleaning And Maintenance - MSW Motor Technics MSW-AWG-3400 Manual De Instrucciones

3.4.

Cleaning and maintenance

a) Unplug the mains plug and allow the device to cool completely before each
cleaning, adjustment or replacement of accessories, or if the device is not
being used.
b) Always unplug the device before cleaning it.
c) Use only non-corrosive cleaners to clean the surface.
d) After cleaning the device, all parts should be dried completely before using it
again.
e) Store the unit in a dry, cool place, free from moisture and direct exposure to
sunlight.
f) Do not spray the device with a water jet or submerge it in water.
g) The device must be regularly inspected to check its technical efficiency and
spot any damage.
h) Use a soft, damp cloth for cleaning.
i) Do not use sharp and/or metal objects for cleaning (e.g. a wire brush or a metal
spatula) because they may damage the surface material of the appliance.
j) Do not clean the device with an acidic substance, agents of medical purposes,
thinners, fuel, oils or other chemical substances because it may damage the
device.
DISPOSING OF USED DEVICES
Do not dispose of this device in municipal waste systems. Hand it over to an electric
and electrical device recycling and collection point. Check the symbol on the
product, instruction manual and packaging. The plastics used to construct the device
can be recycled in accordance with their markings. By choosing to recycle you are
making a significant contribution to the protection of our environment.
Contact local authorities for information on your local recycling facility.
TROUBLESHOOTING
Problem
Only cold air
Air pumps
make noise /
spark
formation
Specific noise Bearing abrasion
Possible cause
Heating element
probably damaged
Worn carbon brush in
motor
Remedy
Remove the metal tube to replace the
heating element
If the problem persists, the temperature
controller may be faulty.
Replace the carbon brush with a new
one.
Replace the bearings.