Learn To Use Walkingpad; Error Code - KingSmith WalkingPad WPP1F Manual Del Usuario

1.4 Learn to use WalkingPad

4. Description of automatic mode control (advance mode)
Automatic mode
This is a challenging and higher class mode. User can
walk on the WalkingPad completely out of remote control-
ler. We only recommend those who have good sports
skills or walking machine experience to take the challenge.
Short press: stop the WalkingPad.
Mode Switch:
Short press: switch to manual mode.
Long press: switch to Standby mode.
11
Entering this area, the
WalkingPad will start or
accelerate under the
automatic mode.
Entering this area, the
WalkingPad will slow down
automatically under the
automatic mode.
5. Remote Controller Notice
If the remote controller has no response or you change a
new one, the remote controller and walking device need
to re-establish communication.
Remote control pairing method:
Restart the WalkingPad, press and hold down the mode
switch button on the remote control immediately, hearing
the sound of "Beep" indicates the success of pairing.
Note: During the operation, the remote control should be
close to the WalkingPad.

6. Error code

The error code is off when the walking machine is work-
ing normally. While error occurs, the display panel of
remote shows the error code.
E01: Drive communication fault;
E02: Motor abnormalities;
E05: Overcurrent protection;
E06: Motor Protection;
E08: Sensor Fault;
E09: Controller connection failure;
E10: High temperature protection, automatic recovery
after the end of countdown;
E11: Overload protection, please add lubricating oil, and
resume automatically after countdown.
12