Preparations For Operation; Operating The Appliance - Royal Catering RC-SHSFL01 Manual De Instrucciones

3.2. Preparations for operation

POSITIONING THE APPLIANCE
The maximum ambient temperature and relative humidity limits not to be exceeded
are +40°C and 85% RH, respectively. Position the appliance where good air
circulation is ensured. Maintain a minimum clearance of 25 cm from all sides of the
appliance. Keep the appliance away from any hot surfaces. Always operate the
appliance out of the reach of children and individuals with reduced mental, sensory
and intellectual capacities. Position the appliance where the power switch can be
reached at any time. Make sure that the mains power ratings match the data on the
rating plate!
INSTALLING THE APPLIANCE
1. Remove the appliance from the box.
2. Remove the tape and protective packaging from all surfaces of the appliance.
3. Suspend the IR heater lamp on a fixture installed (not included) on the ceiling,
e.g. a hook in a wall plug.
4. Suspend the IR heater lamp on the hook or a ceiling suspension fixture. Adjust
the suspension cable length as needed to provide a sufficient, safe clearance
underneath the appliance.
5. Wire the lamp cable to the mains:
• Live (L) is brown;
• Neutral (N) is blue;
• Earth (GND) is yellow/green.
Caution: The appliance must be wired to earth.
Caution: Have a qualified electrician connect the wiring.
6. Move the guard (1) up to touch the ceiling.

3.3. Operating the appliance

1. Turn on the IR heater lamp by operating the power (ON/OFF) switch (3) located
above the shade.
2. For the best results, place the (heat-resistant) container with the food to be held
in heat directly below the IR heater lamp.
3. Once the food reaches the required temperature, operate the power switch (3)
to turn off the lamp.
4. If the lamp will not be used for a long time, disconnect it from the mains.
Caution: This appliance holds heat only and does not continue any cooking/thermal
processing.
Replacing the light bulb:
• To replace the light bulb (5), operate the power switch to OFF wait until the bulb
and the shade cool down completely.