Problem And Solution - Domo DO1097SV Manual De Instrucciones

We advise replacing the filters regularly to ensure an optimal operation of the machine. Dirty filters
will reduce the suction power drastically. After every cleaning, clean the dust reservoir and the filters to
extend the life span of your machine.
CLEANING THE FLOOR BRUSH
1. Remove the floor nozzle from the upright vacuum cleaner. Press the
the floor nozzle and remove it from the machine.
2. Slide the cover on the right side of the floor brush to the right.
3. Remove the
4. Remove hairs and other dirt that have wrapped around the floor brush. If you do not clean the floor
brush regularly, it will become damaged and your machine will become unusable.
5. The rotating floor brush may be rinsed off under running water. Make sure that it is completely
before using it.
6. Place the floor brush back into the floor nozzle when it is clean.
7. Slide the cover closed again to secure the floor brush.
8. Push the nozzle back onto the stick. The machine is now again ready for use.
Stuck hairs can damage the machine or your floor. Always remove the hairs stuck on the brushes.

PROBLEM AND SOLUTION

Problem
The battery charge indicator will
flash on and off.
The machine does not start up.
The machine does not vacuum.
The running time of the machine is
shorter and shorter.
32
DO1097SV
rotating floor brush from the floor nozzle.
·
·
·
·
·
·
·
·
·
Solution
The battery is empty. Charge the machine.
The battery is empty. Charge the machine.
The filters are dirty/the dust reservoir is full.
The floor nozzle is clogged/the floor brush is blocked.
Clean the machine as described in this manual.
The filters are dirty/the dust reservoir is full.
The machine is not sufficiently charged. Charge the
machine fully and try again.
The battery is broken or old. Contact the after sales service.
Stuck hairs. Remove the hairs stuck on the brushes.
release button at the back of
dry