Warranty & Service; General Safety Rules - Craftsman 900.11651 Manual De Instrucciones

1006292-00 11651 grinderREV
1
Spindle Lock Button (3)
Depressed Center Wheel (4)
FULL ONE YEAR WARRANTY ON CRAFTSMAN ANGLE GRINDER
If this Craftsman angle grinder fails due to a defect in material or workmanship within
one year from the date of purchase, Sears will replace it, free of charge.
If this Craftsman angle grinder is used for commercial or rental purposes, this warranty
applies for only 90 days from the date of purchase.
WARRANTY SERVICE
To obtain replacement under this warranty, return the grinder to your nearest Sears store
in the United States.
This warranty applies only while this angle grinder is used in the United States.
This warranty gives you specific legal rights, and you may also have other rights which
vary from state to state.
SEARS, ROEBUCK AND CO., DEPT. 817 WA, HOFFMAN ESTATES, IL 60179
WARNING! Read and understand all
instructions. Failure to follow all
instructions listed below may result in
electric shock, fire and/or serious personal
injury.
SAVE THESE INSTRUCTIONS
Work Area
• Keep your work area clean and well lit.
Cluttered benches and dark areas invite
accidents.
• Do not operate power tools in
explosive atmospheres, such as in the
presence of flammable liquids, gases,
or dust. Power tools create sparks which
may ignite the dust or fumes.
• Keep bystanders, children, and
visitors away while operating a power
tool. Distractions can cause you to lose
control.
4/16/07 10:53 AM
ANGLE GRINDER DIAGRAM
SEARS WARRANTY

GENERAL SAFETY RULES

Electrical Safety
• Double insulated tools are equipped
with a polarized plug (one blade is
wider than the other.) This plug will fit
in a polarized outlet only one way. If
the plug does not fit fully in the outlet,
reverse the plug. If it still does not fit,
contact a qualified electrician to install
a polarized outlet. Do not change the
plug in any way. Double Insulation
eliminates the need for the three wire
grounded power cord and grounded
power supply system. Applicable only to
Class ll tools.
• Avoid body contact with grounded
surfaces such as pipes, radiators,
ranges and refrigerators. There is an
increased risk of electric shock if your
body is grounded.
• Don't expose power tools to rain or
wet conditions. Water entering a power
tool will increase the risk of electric shock.
2
Page 2
Lock-On Button (2)
Trigger Switch (1)
Auxiliary Side Handle (5)
Wheel Guard (6)