Control Panel; Installation Instructions - Comedes Demecto 10 Manual De Instrucciones

Figure 2:
air inlet / housing rear side

Control panel

Figure 3:
defrost

Installation instructions

Operate the device only in rooms with at least 6m² floor space.
Remove all adhesive tapes that have been used to secure the unit during
transport.
Check that the unit stands securely on a firm, level and dry surface.
Make sure that the device cannot cause any water damage even if the water tank is
leaking.
Before putting the unit into operation, always leave it in its final position for at least 2
hours to allow the refrigerant to settle and to avoid the risk of compressor damage.
humidity sensor
hose connection
water tank
Tank full
Speed
On / Off