Technical Data; Installation Instructions - Franke KUBUS PULL DOWN FF4250 Manual De Instalación

Technical data

Operating data
Operating pressure (ideal)
Operating pressure (max.)*
Operating pressure (min.)*
Water temperature (ideal)
Water temperature (max.)
Hole Size For Faucet
Certifies this faucet complies with ASME A112.18.1 / CSA B125.1 & NSF 61, NSF 372 and
AB1953. The faucet also complies with water usage requirements of the California
Energy Comission and the US Department of Energy.

INSTALLATION INSTRUCTIONS

1. Remove all contents from the package
and check for completeness.
2. Turn off water supply.
3. Cut a mounting hole 1 3/8" diameter
(35mm) in the desired mounting surface
(if one isn't available).
4. Ensure Rubber O-ring (2) is in place in
the Faucet Base (1) (fig. 2A).
2A
1
2
5. Insert the faucet into the hole, hoses
first (fig. 2B)
ATTENTION: Rubber O-Ring (2) should
be sitting between the countertop and
faucet base.
DO NOT use putty or other sealant at
this location.
NOTES: Solid surface installation: The
countertop mounting surface needs to be
Value
60 PSI 4 bar 400 kPa
115 PSI 8 bar 800 kPa
30 PSI 2 bar 200 kPa
140°F 60°C
158°F 70°C
1 3/8 " 35mm
flat and free of debris; otherwise the faucet
may not sit properly and could leak.
6. Install the mounting hardware to the
mounting shank of the Faucet Base (1)
underneath the mounting surface in the
following order: Rubber Washer (3), Plastic
Flange (4) and Fixing Plate (5) (fig. 2B).
2
2B
– 5 –
3
4
5
6
7 Nm
EN