Declaration Of Conformity; What's In The Box; Inserting The Batteries - EUFY Smart Scale P2 Pro T9149 Manual Del Usuario

Address: 400 108th Ave NE Ste 400, Bellevue, WA 98004-5541
Telephone: +1 (800) 988 7973
RF Exposure Compliance Statement
This equipment complies with FCC/IC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with a minimum distance of
20cm between the radiator and your body.
ISED Compliance Statement
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation,
Science and Economic Development Canada's licence-exempt RSS(s). Operation is subject
to the following two conditions:
1. This device may not cause interference.
2. This device must accept any interference, including interference that may cause undesired
operation of the device.

Declaration of Conformity

This product complies with the radio interference requirements of the European Community.
Hereby, Anker Innovations Limited declares that the radio equipment type T9149 is in
compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is
available at the following internet address: https://www.eufylife.com/.
GB Declaration of Conformity
Hereby, Anker Innovations Limited declares that the product type T9149 is in compliance
with Radio Equipment Regulations 2017 and The Restriction of the Use of Certain Hazardous
Substances in Electrical and Electronic Equipment Regulations 2012. The full text of the GB
declaration of conformity is available at the following internet address:
https://www.eufylife.com/
The following importer is the responsible party (contract for EU and UK matters)
Anker Technology (UK) Ltd
Suite B, Fairgate House, 205 Kings Road, Tyseley, Birmingham, B11 2AA, United Kingdom
Anker Innovations Deutschland GmbH
Georg-Muche-Strasse 3, 80807 Munich, Germany
Anker Innovations Limited
Room 1318-19, Hollywood Plaza, 610 Nathan Road, Mongkok, Kowloon, Hong Kong
06 EN

What's In the Box

Smart Scale
Soft Measuring Tape
(60in / 150cm)

Inserting the Batteries

Turn the scale over and place it on a flat surface.
Open the battery door and insert 4 AAA batteries. Make sure the positive
and negative ends are facing the correct polarity directions marked in the
battery compartment.
- The digits will show on the LED display.
Press down to close the battery door. Make sure the battery door is fixed in place.
AAA Battery (×4)
Owner's Manual &
Other Documents
EN 07