Maintenance & Cleaning - KRHÜNER 80796 Manual De Instrucciones

SCREW INSERTION
• Set the direction of rotation of the screwdriver to the clockwise direction.
• Insert the screw-bit into the slot in the head of the screw.
• Hold the screw bit perpendicular to the head of the screw, otherwise the screw or
the screw head may be damaged.
• Press the screw bit against the screw with a constant pressure while driving in the
screw.
• When the screw is completely screwed in, hold the machine firmly and release the
On/Off trigger, otherwise the screw or the screw head may be damaged.
• If the On/Off trigger is not released immediately a high torque could also damage
the screw-bit or the screwdriver.
SCREW REMOVAL
• Set the direction of rotation of the screwdriver to the anticlockwise direction.
• Insert the screw-bit into the slot in the head of the screw.
• Hold the screw-bit perpendicular to the head of the screw, otherwise the screw or
the screw head may be damaged.
• Press the screw bit against the screw with a constant pressure while removing the
screw.
3. MAINTENANCE & CLEANING
WARNING! Switch off before adjusting or cleaning. The bit holder continues to
move for a few seconds after the machine is switched off. CAUTION! Do not touch the
moving bit holder.
• ATTENTION! Always switch off the screwdriver and lock the switch in the OFF posi-
tion before carrying out any work on the machine.
• To clean, always use a dry or moist, but not wet towel. Many cleaning agents contain
chemical substances which may cause damage to the plastic parts of the machine.
Therefore do not use any strong or inflammable cleaners such as petrol, paint thin-
ner, turpentine or similar cleaning agents.
• Always keep air ventilation holes free of dust deposits to prevent overheating.