Inserting The Battery; Removing The Battery; Starting Operation - Bosch UniversalLamp 18 Manual Original

16 | English
Note: Lithium-ion rechargeable batteries are supplied partially charged according to in-
ternational transport regulations. To ensure full rechargeable battery capacity, fully
charge the rechargeable battery before using your tool for the first time.

Inserting the Battery

Push the charged battery into the battery holder until it clicks into place.

Removing the Battery

To remove the rechargeable battery, press the battery release button and pull the bat-
tery out. Do not use force to do this.
Recommendations for Optimal Handling of the Battery
Protect the battery against moisture and water.
Only store the battery within a temperature range of –15 to 50 °C. Do not leave the bat-
tery in your car in the summer, for example.
A significantly reduced operating time after charging indicates that the battery has de-
teriorated and must be replaced.
Follow the instructions on correct disposal.
Operation

Starting Operation

Switching on/off and adjusting the brightness
On/off switch
Press 1×
Press 2×
Press 3×
Utility hook (see figure B)
You can use the utility hook (2) to attach the cordless worklight to an object.
Swivelling the lamp head (see figure C)
The lamp head (1) can be swivelled up to 110° to suit the application.
1 609 92A 850 | (31.08.2022)
Function
Switches on the cordless worklight, full brightness
Switches on the cordless worklight, dimmed
Switches off the cordless worklight
Bosch Power Tools