Battery Replacement; Cleaning - Black Diamond Equipment RECON LT Manual De Instrucciones

6.2 BATTERY REPLACEMENT

Change the battery as soon as the battery capacity indication (2D) shows an empty battery. Move switch lock (1C)
away from switch (1B) and rotate switch counterclockwise. Align switch marking with white dot on rear cover. Lift
the switch from the battery compartment (1H). Install battery, making sure orientation matches icon on rear
cover. Align the metal insert on the switch to the relief in the battery compartment and put into position (this is
the same alignment as switch removal.) Turn the beacon to "Send", making sure that the switch lock secures the
switch in place.
For battery disposal, follow the applicable regulations in your country.
DANGER Risk of explosion from incorrectly used batteries
Risk of incorrect battery capacity indication
Only use batteries of type 1x Alkaline (AA) LR06 1.5 V or 1x Lithium (AA) FR06 1.5V!
The use of Lithium batteries must be confirmed in the PIEPS APP!
Battery lifetime
RECON LT
3/3 full
2/3 full
1/3 full
empty
empty, blinking

6.3 CLEANING

Use a damp cloth without cleaning agents to clean the device.
NOTICE Flowing water, steam or cleaning agents must not be used to
clean the device. To do so could impede operation of the
device.
Manual BLACK DIAMOND RECON LT
Alkaline
200 h SEND
100% - 66% SEND
66% - 33% SEND
33% - 20 h
20 h SEND (+10° C, 50° F) + 1 h SEARCH (-10° C, 14° F)
Final reserve, device can shut down at any time
Lithium
350 h SEND
13 / 21