SPECIFIC SAFETY INSTRUCTIONS FOR JIG SAWS
ො Hold the power tool by the insulated gripping surfaces, when performing an operation
where the cutting accessory may contact hidden wiring or its own cord. Cutting acces-
sory contacting a "live" wire may make exposed metal parts of the power tool "live"
and could give the operator an electric shock.
ො Use clamps or another practical way to secure and support the workpiece to a stable
platform. Holding the workpiece by hand or against your body leaves it unstable and
may lead to loss of control.
Important! The use of any accessories or attachments other than those supplied
or recommended in these operating instructions can mean the risk of injury.
ො When using jig saws ear protectors and a face mask should be worn. Exposure to noise
can cause damage to hearing.
ො Do not use the jig saw to cut asbestos or materials containing asbestos.
ො Do not leave power tools running unattended. Always switch off and do not put down
or leave until it has stopped completely.
ො Long hair must be covered. Do not work in loose fitting clothing.
ො Be careful when working on walls. Damage to power supply lines, gas or water pipes
can lead to dangerous situations. Use appropriate detectors to establish whether there
are concealed wires or pipes in the working area.
ො Always check that the mains voltage corresponds to the voltage on the device's rating
plate.
ො Secure the work piece. The work piece is only secure if it is held by work-holding devices
or in a vice.
ො Use of extension cables. Only use extension cables which are designed for the ma-
chine's power. The minimum conductor cross section must be 1.5 mm². When using
cable reels the cable must always be completely unrolled.
ො Always remove the mains plug before replacing saw blades.
ො Caution: saw blades can get very hot.
ො Saw blades must be kept sharp and in good condition. Replace partially fractured and
broken saw blades immediately.
ො Work calmly and evenly with the jig saw. You will thus avoid accidents and the saw
blades and the jig saw will last longer.