KRHÜNER 80757 Manual De Instrucciones página 12

Note: there is no need to fully loose the two screws to assemble or remove the saw
blade; fully loose the two screws may cause less space between the screw head and
the protection part, which may cause the hex wrench not convenience to twist the two
screws.
Important! : Make sure the saw blade sits properly in the slot of the roller and
groove.
Switching ON/OFF
• Switching ON : Press the On/Off switch.
• Continuous operation. Lock the On/Off switch with the locking button.
• Switching Off : Press the On/Off switch and release.
Adjusting the base
• Undo the 2 screws to set the base to an angle up to 45° on the right or left side.
• The blade guide is adjustable by undoing the two screws to keep the blade working
more stable.
Sawing tips
A. Cutting veneered chipboard:
• Use a fine saw blade.
• Position the base on the uncovered area.
• Advance the saw with little force.
B. Cutting holes:
• Possible only in chipboard and wood unless you drill a hole first.
• Press the jig saw firmly against the support and move it slowly in the cutting direction.
Dust extraction
The jigsaw is equipped with a dust extractor socket. You can connect your vacuum clean-
er to the socket at the rear of the jigsaw. If you require a special adapter, please contact
the manufacturer of your vacuum cleaner.