Supporting Command Class Basic; Supporting Command Class Indicator; Notification Command Class; Associations - Airzone Aidoo Z-Wave Plus AZAI6ZW Serie Manual

Command class
SECURITY_2
SUPERVISION
FIRMWARE_UPDATE_MD
THERMOSTAT_FAN_MODE
THERMOSTAT_MODE
THERMOSTAT_SETPOINT
SENSOR_MULTILEVEL
NOTIFICATION

Supporting command class basic

Implemented Mapping:
Basic Command Received
Basic set (0xxFF)
Basic set (0xx00)
Basic GET
The basic command classes are mapped into the Thermostat Mode Command Class as
required by the protocol specification.

Supporting command class indicator

The Aidoo Z-Wave Plus supports Indicator V3 with Indicator ID 0x50 (identity). When the device
receives an indicator set, the backlight

Notification Command Class

The system implement notification command class with Type: System (0x09) and event:
System hardware failure (manufacturer proprietary failure code provided).
Manufacturer proprietary failure code provided are 2 bytes length (error and warning). The
meaning of these bytes are described into the Air conditioning manufacturer's installation
manual.

Associations

Lifeline group: Nodes belonging to this group will receive: notifications about device reset and
all other changes.
Mapped Command (Thermostat Mode)
If the last non Off mode was 1 or 2 -> Thermostat Mode(last non
Off mode). Otherwise -> Thermostat Mode (0x01)
Thermostat Mode (0x00)
Replay with a basic Report with these meaning:
Basic Report 0x00 if mode is equal to 0x00
If mode different than 0 reply with Basic Report 0xFF
start to blink accordingly the received command.
Version Non-Secure CC Secure CC
1 x
1 x
5
2
3
1
1
8
x
x
x
EN
x
x
x
11