Uline H-9022 Instrucciones De Asamblea página 2

2. Turn the base over onto its casters and attach
cabinet supports to outside of base using two long
Phillips head bolts and two 6 mm locknuts per
cabinet support. (See Figure 2)
NOTE: End of cabinet supports with four holes
should face center of base.
Figure 2
3. Attach cabinet back to back side of cabinet
supports using eight short Phillips head bolts.
(See Figure 3)
NOTE: Lip of cabinet back should be on bottom
and face inside of cabinet.
Figure 3
Short Phillips
Head Bolt
PAGE 2 OF 12
ASSEMBLY CONTINUED
6 mm
Locknut
Long Phillips
Head Bolt
4. Attach bottom lip of cabinet back to base using
three short Phillips head bolts and three 5 mm
locknuts. (See Figure 4)
Figure 4
5. Attach outer supports to outside of base using two
long Phillips head bolts and two 6 mm locknuts per
support. (See Figure 5)
NOTE: Louvers on outer supports should face
inside.
Figure 5
Louver
6 mm
Locknut
Long Phillips
Head Bolt
Short Phillips
Head Bolt
5 mm
Locknut
1220 IH-9022