Filling Instructions - Oster GCSTGS7000-013 Manual De Instrucciones

OPERATING INSTRUCTIONS

Filling instructions

1. Remove the water tank from the unit.
2. Turn the cap of the water tank.
3. Fill water up to the MAX Line and tighten the cap.
4. Place the water tank on the unit making sure it snaps firmly into place.
5. Your garment steamer is ready to use.
Note: Water Varies By Region. To ensure that your garment steamer
continues to function, never store the unit with water in the tank.
Caution the unit releases hot steam, please be sure to handle the
nozzle carefully and away from any part of the body. Do not use the
garment steamer with clothes on. Do not point the mouthpiece towards
your face.
How to use
1. Make sure the water tank has water.
2. Plug the unit into a suitable electrical outlet.
Warning: Care must be taken to position the cord so that it cannot be
pulled or tripped over. Always make sure that you can move freely without getting tangled in the
cable.
3. Press the push button to the ON «I» position. The button turns red. Wait a few seconds before
for steam to start to come out.
Note: You may hear a knocking sound during the warm-up cycle. This is normal.
4. Grip the steam nozzle handle with the steam holes facing outward. Remove the nozzle from
the garment and smooth the fabric with your free hand or glove.
5. We do not advise to use this product horizontally. This product was designed for vertical use.
6. To turn off the garment steamer, turn the switch to the OFF «O» position.
7. Unplug the device when not in use. Empty the reservoir and allow the garment steamer to cool
down before storing.
Accessories
Make sure the garment steamer is unplugged and cool before applying attachments. If the unit
has been in use, allow the unit to cool down completely first before changing attachments as the
press plate will still be hot.
i. The fabric brush separates the fibers on thicker fabrics for better steam penetration. To affix
the attachment, snap the fabric brush over the press plate.
ii. Provided pants line clip for making proper pants line, align and insert the slider into Nozzle slot
before using.
iii. The cord management accessory on the bottom of the pole will help you to role the cord when
the unit is not in use.
GCSTGS7000_22SEM4 (LA).indd 5 GCSTGS7000_22SEM4 (LA).indd 5
English - 5
2022/3/28 下午4:45 2022/3/28 下午4:45