Operation - Truper DES-63 Manual

Starting the Motor When Hot
• Set the Gas Brushcutter on levelled ground using care
the blade is not making contact with any obstacle.
• Set the switch in the ON position (H).
• Press and release the Primer bulb 10 times (I).
• Press simultaneously the trigger release and the throttle
trigger. Still holding the trigger, push in the throttle lock
button and release the trigger.
• Pull the jack-line (J) until the motor starts.
• Press and release the throttle trigger to make the motor
run idle (K).
Shut Down
• Press and hold the switch into the OFF position (E) until
the motor stops.
E
CAUTION
• Keep in mind that you as a Gas
Brushcutter operator are responsible of your safety as well
as those who are close to the work area. Follow all safety
standards (pages 4 and 5) before operating the Gas
Brushcutter.
• Keep a balanced stance with both feet firmly supported
on the ground.
• Firmly hold the Gas Brushcutter in front of you. One
hand on the handle and the other hand on the auxiliary
handle. Keep the Gas Brushcutter aligned to your body
and point the cutter head 30° downwards away from your
feet.
DANGER • Do not start or operate the Gas
Brushcutter in a different stance.
• Start the Gas Brushcutter and cut from left to right while
rotating your waist. Keep the Gas Brushcutter position.
• As you cut, the cutting thread will wear out and will fall
apart. To release more thread from the spool, press the
Gas Brushcutter a little bit downwards. This position will
make the ground to press the retention cap against the
spool to release more thread. The remaining thread is cut
with the guard blade. At this moment stop pushing the Gas
Brushcutter against the ground to avoid wasting thread.
• To cut brush or high grass make it gradually. Do not try
to cut in one pass from the base because residues can get
stuck in the cutter head or make you lose control over the
Gas Brushcutter.
10
ENGLISH
Start Up
H
J

Operation

30°
I
x10
K
Waist
Rotation
Cutting
Movement