Uline H-9823 Manual De Instrucciones página 2

3. Slide posts through underside of shelf until shelf
slides firmly over supports. (See Figure 3)
Figure 3
4. Stand unit upright. Gently tap shelf down with rubber
mallet to secure it. (See Figure 4)
Figure 4
Front Track with Connector x 2
Front Track without Connector x 1
Back Track x 3
PAGE 2 OF 15
SHELVING ASSEMBLY CONTINUED
TRACK PARTS
Front End Connector x 2
Back End Connector x 2
Back Track Connector x 2
A
Front End Connector Screw x 4
5. Determine the height of
the next shelf, snap on
shelf supports, then add
and secure shelf. Repeat
this step to add remaining
shelves. (See Figure 5)
NOTE: Leave at least
one groove open
at the top of
the 72" posts.
MOBILE SHELVING UNITS
1. Mobile units use four 63" posts. To install casters,
ensure post is positioned as shown. (See Figure 6)
Figure 6
2. Engage the wheel brakes to keep casters from
rolling during assembly. Use a rubber mallet to tap
caster stems into posts. (See Figure 6)
3. Repeat steps 2-5 from stationary unit assembly to
complete mobile unit assembly for two or three
mobile units.
Figure 5
Plastic End Cap x 2
B
Back Track Connector Screw x 12
C
Front Track Connector Screw x 12
D
Lock Washer x 16
0222 IH-9823