Uline H-9823 Manual De Instrucciones página 3

BACK TRACK
1. Lay all three back track pieces in a row.
(See Figure 7)
Back Track
Figure 7
2. Attach one back track connector between the left
and middle tracks. (See Figure 8)
a. Slide connector into track until holes align.
b. Use four back track connector screws (B) and
lock washers (D) to attach. (See Figure 8)
3. Repeat step 2 to connect the right and middle
tracks together.
Figure 8
4. Attach one back end connector to each side of the
track using two back track connector screws (B) and
lock washers (D). (See Figure 9)
Figure 9
PAGE 3 OF 15
TRACK ASSEMBLY
FRONT TRACK
1.
Back Track
Connector
2. Slide the connector tracks into the open slots on the
3. Use six front track connector screws (C) to connect
B
D
4. Repeat step 3 to connect the middle and left tracks
B
D
Lay all three front track pieces in a row.
(See Figure 10)
NOTE: The front track without connector should
be on the left.
Front Track
without Connector
Front Track
with Connector
Figure 10
corresponding tracks. (See Figure 11)
the middle and right tracks together. (See Figure 11)
Figure 11
together.
Front Track
with Connector
C
0222 IH-9823