HQ-Power MINI STARDUST III Manual Del Usuario página 3

4. Description
1. power cord input with fuse
2. DMX input
3. DMX output
4. remote control input
5. voltage selector
5. Installation
a) Mounting the Device
• Have the device installed by a qualified person, respecting EN 60598-2-17 and all other applicable norms.
• The carrying construction must be able to support 10 times the weight of the device for 1 hour without deforming.
• The installation must always be secured with a secondary attachment e.g. a safety cable.
• Never stand directly below the device when it is being mounted, removed or serviced. Have a qualified technician check
the device once a year and once before you bring it into service.
• Install the device in a location with few passers-by that is inaccessible to unauthorised persons.
• Overhead mounting requires extensive experience: calculating workload limits, determining the installation material to be
used... Have the material and the device itself checked regularly. Do not attempt to install the device yourself if you lack
these qualifications as improper installation may result in injuries.
• Adjust the desired inclination angle via the mounting bracket and tighten the bracket screws.
• Make sure there is no flammable material within a 0.5 m radius of the device.
• Have a qualified electrician carry out the electric connection.
• Connect the device to the mains with the power plug. Do not connect it to a dimming pack.
• The installation has to be approved by an expert before the device is taken into service.
b) Fuse
• Only fit or replace a fuse when the device is unplugged from the mains.
• Replace a blown fuse with a fuse of the same type and rating (see "Technical Specifications"):
1. Remove the fuse holder using a flat screwdriver.
2. Remove the old fuse and install a new one.
3. Replace the fuse holder.
6. Operation
a) Control Panel
Button
<MODE/ESC>
<UP>
<DOWN>
<ENTER>
VDPL1501MHW-B / VDPL1501MHW-W_v4
Access to menu or return to previous menu option.
Scroll up through menu.
Scroll down through menu.
Select and store displayed menu option.
Function
3 HQPOWER