Jeep JE-MX27.5+ Manual De Instrucciones página 19

1. Turn off the bike. Do not use the bike when charging the battery.
2. Ensure the charging port is dry.
3. Open the cover and insert the charger plug into the bike charging port.
Then, the other end of the charger must be connected to the mains to activate the charger.
4. The indicator light on the charger will be red: this grants that the charge is proceeding.
5. After 3-5 hours of charging, the light of the charger will be green: the battery is fully charged. Too long
charging time will affect the battery life.
6. When charging is finished, remove the cable of the charger from the charging port of the bike. Disconnect
the plug from the 230 V outlet and then disconnect the battery charger from the battery itself.
Close the protection cover when the charging procedure is finished.
Charging should be in a safe, dry and clean environment.
Do not charge the battery if the temperature is lower than 0°C.
Use the original charger only.
If you store the bicycle, remember to regularly recharge the battery at least every two months, to avoid loss
of battery capacity.
WARNING
The battery contains dangerous substances.
Do not charge the battery if the temperature is lower than 0°C.
Do not attempt to open the battery and do not insert objects inside it.
Do not charge overnight or when you are not able to observe the e-bike.
19