BST ASB-PRO Manual De Uso página 4

4 • ASB-PRO
4. If you don't use the unit for a longer period of time, it is recommended to charge it at 40% of its capa-
city and check/charge it once per month.
The life time of the battery depends on the observance of these recommendations.
** BATTERIES ARE NOT COVERED BY THE WARRANTY **
We cannot be held responsible for damaged batteries further to the non-observance of these basic
ON-OFF-CHARGE ONLY
Though the battery will always charge while the unit is connected to AC power, "Charge Only" enables you
to charge your battery more quickly. To enable quick charge, turn the power switch to CHARGE ONLY when
the unit is not in use.
It takes generally 4 hours to fully charge the battery. The operating time with a fully charged battery at 100%
volume is 2 hours.
FEATURES
• Bluetooth with TWS function
• 3 channels: 2 balanced Mic/Instrument combo inputs with volume control; 1x RCA stereo input
• Class D amplifier
• Separate Bass & treble controls
• Reverb function
• 24 bits / 96kHz DSP
• Rechargeable batteries for 6 hours of use
• Power, Signal & Clipping indicators
• 35mm insert for stand mounting
• Slanted shape for tilt, stage monitor or wall mount
• Top-mounted handle
Control Panel
1. Signal/Clip indicator:
Green : Signal present
Red: Signal clipping
Note: Reduce the corresponding volume control to prevent signal clipping
2. Volume control of the microphone, instrument or other audio source
3. Adjustment of the high frequency balance of your microphone or instrument
4. Adjustment of the low frequency balance of your microphone or instrument
5. Adjust the amount of reverb applied to your microphone or instrument
6. Press to select mic or guitar input
7. Analog input for a microphone (XLR) or instrument (unbal. Jack)
8. RCA input jacks for connection of line sources (e.g. mixer, audio interface, bal/unbal line out) for left
and right channel
9. Connect an XLR cable to the line level output to the CH1 or CH2 input of a second ASB-PRO to create a
mono, 2-speaker setup. Please note: Line Out is post mix.
10. TWS/Reset: Press the TWS buttons on both ASB-PRO simultaneously and wait until they are paired
(one TWS LED blinks slowly, the other one doesn't blink). Start searching for Bluetooth devices on
rules.