Before Use - Casals MT300EK Manual De Instrucciones

or medical/hospital use, it is intended for
household use only.
- This appliance is not a toy. Children should be
supervised to ensure that they do not play with
the appliance.
- This appliance is intended for adult use.
Ensure that this product is not used by the
disabled, children or people unused to its
handling.
- This appliance should be stored out of reach of
children and/or the disabled.
- Do not expose the appliance to extreme
temperatures.
- Keep the appliance in good condition. Check
that the moving parts are not misaligned or
jammed and make sure there are no broken
parts or anomalies that may prevent the
appliance from operating correctly.
- Keep the cutting tools sharp and clean.
- Let the appliance running with no load
for 30 seconds in a safe position. If you notice
serious vibration or other defects stop the
appliance immediately. Then check the problem
and /or proceed as we describe on Anomalies
and Repair clause.
- Always check the workpiece before operation
and remove any obstructions such as nails,
staples, screws, string, rags, cloths and other
debris.
- Check the position of power cables before
commencing work ensuring they are well away
from the work area.
- Keep hands and other body parts well away
from the work area whist the tool is in use.
Service:
- Make sure that the appliance is serviced only
by specialist personnel, and that only original
spare parts or accessories are used to replace
existing parts/accessories.
- Any misuse or failure to follow the instructions
for use renders the guarantee and the
manufacturer's liability null and void.
Instructions for use
Always be sure that the tool is switched off and
unplugged before carrying out any work on the tool.

Before use:

- Make sure that all the product's packaging has
been removed.
- Prepare the appliance according to the
function you wish to use:
Fitting the accessories (Fig.1)
- Unplug the appliance from the mains.
- If an accessory is assembled loosen the screw
(I) using the Allen wrench (K)
- Mount the accessory (F) or (G) on the tool
holder (E). The pins of the tool holder (E) must
engage in the openings of the accessory ( F)
or (G)
- For a more comfortable work you can mount
the accessories (F) or (G) in any snap-in position
on the tool holder (E).
- Fasten the accessory (F) or (G) on the tool
holder (E). Tighten the screw and the nut (I) on
the tool holder (E) with the allen Wrench (K)
- Check that the accessory (E) or (G) is securely
fasten.
Fitting the sanding pad (Fig.1)
- Unplug the appliance from the mains.
- Mount the accessory (H) on the tool holder (E).
The pins of the tool holder (E) must engage in
the openings of the accessory (H)
- Fasten the accessory (H) on the tool holder (E).
Tighten the screw and the nut (I) on the tool holder (E)
with the allen Wrench (K)
- Check that the accessory (H) is securely fasten.
Fitting/Replacing a sanding sheet the
accessories (Fig.1)
- Ensure the sanding pad (H) is clean from any
debris.
- Take sanding paper (J) of the required grain size
and place on the sanding pad (H)