The groove is
located at back
9. Stand the previous assembly at its back panel.
10. Align and attach the Drawer Front Panel (G) to both Drawer Sides (I and J) and Drawer Bottom Support
(K). fasten it in place by engaging six Small Cam Locks (1). (Refer to page 2 on Cam Lock system
operation supplement). Make sure that the Drawer Bottom Panel (L) fits securely into the groove of the
Drawer Front Panel (G).
11. Complete the step once again for the other drawer
12. Turn the assembled utility drawer upright and attach one Handle (7) to the front side of the Drawer Front
Panel (G) with two 12 mm Screws (6).
13. Complete the step once again for the other drawer.
Assembly Instructions
G
K
L
J
I
G
9
2
x
2
x