BaByliss Elegance i pro 230 steam Manual página 8

• check that your hands and the
outside of the reservoir are
dried well.
If the reservoir is full, you can
use the steam function about
50 times. If you have to fill
the reservoir a second time,
unplug the unit and replace
the reservoir immediately after
filling it making sure you don't
touch the hot plates.
Let the unit heat up for at least
2-3 minutes before using the
steam function.
Avoid any contact between the
hot surfaces and your face or
neck.
Make sure you don't direct the
steam at your face or neck.
• Prepare your hair for straigh-
tening: wash your hair and
untangle using a big tooth comb
and then dry using a hairdryer.
• Divide your hair into sections. Pin
the upper sections with clips to
work with the hair underneath.
• Remove the little reservoir (3)
located at the top of the unit and
fill it with water, preferably distilled
(first lift the little black rubber
button). Then put the reservoir
back on the straightener.
• Plug the BaByliss i pro 230 steam
straightener in and press the
ON/OFF (1) button. Wait a few
minutes until the straightener has
heated up.
The first time you use the unit, you
might notice a little smoke and a
particular odour: this is common
and will disappear the next time you
use the unit.
You will also notice that the unit
sputters slightly, this sound is normal
for a high output ion generator.
• Select the desired temperature
using the temperature selectors
(2). A lower temperature is
generally recommended
fine, bleached and/or damaged
hair, and a higher temperature
for curly, thick and/or difficult to
style hair. Use the table below as
a guide:
8
for