Alpina YH-40R-0 Manual De Instrucciones página 5

ASSEMBLY INSTRUCTIONS
Assembling the Fan Base:
1. Take the two cross base and push the
4 end caps onto the ends. Cross them
over together as Fig 1.
2. Remove the 4 screws from the base,
then fix the tube to the base by 4 screws.
Take out the Height Adjustment Knob from
the External Tube, slide the Base Cover
down over the base. Then release the
Inner Tube from the External Tube until it
is fully extended, tighten the Height
Adjustment Knob. See Fig 2.
3. Attach the fan body onto the top of Inner
Tube and tighten it by Locking Screw.
Now you can assemble the Fan Head Section:
1. Loosen the Blade Fastener and Rear Grill Fastener from the Motor
Housing.
2. Place the Rear Grill onto the Motor Housing. Tighten the Rear Grill
Fastener in clockwise.
3. Push the Blade onto the Motor Shaft. Tighten the Blade Fastener in
anticlockwise.
4. Fixed the Logo Plate onto the Front Grill by screws. Place the Front
Grill onto the Rear Grill and secure in place using the Grill Clip and
the small security screw.
Fig 1
Fig 2