Publicidad
Idiomas disponibles
Idiomas disponibles
If the connecting cable is getting damaged or cut during the
work, don't touch it but instantly pull the plug out of the socket.
Never use the machine with damaged connecting cable.
The machine must neither be wet, nor be used in humid
ambient conditions.
▪
Do not use the tool for mixing materials either in danger of explosion
(petrol, diluent).
▪
Modifications of the tool are prohibited.
▪
Always check the tool, cable and plug before use. Have damages only
repaired by specialists. Only insert the plug into the socket when the tool
switch is OFF.
▪
When the machine runs outside, always use a protection switch (30 mA
max.) against fault current.
▪
The machine should only run under supervision of somebody.
▪
Pull the plug and switch the machine off if it is not under supervision, e.g.
in case of setting up and stripping down the machine, in case of voltage
drop or when fixing or mounting an accessory.
▪
Switch the machine off if it stops for whatever reason. This way, you
avoid that it starts suddenly and not under supervision.
▪
Always lead the cable to the back, away from the machine.
▪
Do not use the machine if a part of the housing is damaged or in case of
damages on the switch, the connecting cable or plug.
▪
Power tools have to be inspected by a specialist in regular intervals.
▪
Do not touch rotating parts.
▪
Be careful with long hair. Only work with close-fitting clothes.
▪
Persons under 16 years of age are not allowed to use the machine.
▪
When working with this machine wear ear protectors, goggles and
protective gloves.
▪
During use, always hold the machine with both hands and maintain
a safe standing position.
Pay attention to the reaction moment of the machine.
For further safety instructions, refer to the enclosure.
Before starting the machine check the correspondence between voltage and
frequency according to the data mentioned on the identification plate.
Voltage differences from + 6 % and – 10 % are allowed. The stirrer is made
in protection class II. Only use extension cables with a sufficient cross-
section. A cross-section which is too small could lead to an excessive power
loss and to an overheating of motor and cable.
Electrical Connection
12
Publicidad
